Delta PRO Setup Guide

SETUP GUIDE

Delta PRO SC

Downloads:

Mounting

(If your Wheel already comes with the QR attached you can skip this step)

Connect to PC diagram

Connect QR Cable

1
Unwind the Cable
Carefully unwind the cable from the QR to ensure it is fully free and not twisted or under tension.
2
Align the Connector Correctly
Make sure the keyed connector is properly aligned with the socket on the PCB. Misalignment can cause permanent damage to the connector pins.
3
Insert the Connector Securely
With correct alignment, firmly plug the cable connector from the QR into the socket to achieve a solid and reliable connection.
Connect to PC diagram

Mount Simucube QR

4
Position and Align the Simucube QR
Place the Simucube QR on the rear side of the steering wheel and align it with the three threaded holes of the wheel. Ensure that the wheel’s threaded holes match the non-threaded screw slots of the QR.
5
Check Cable Clearance
Pay special attention that the cable is not squeezed or trapped between the QR and the steering wheel before tightening.
6
Tighten the QR Securely
Fasten the QR using 3x screws of appropriate length until it sits firmly in place. Do not exceed a maximum torque of 2.5 Nm per screw.

Software

Together with Simucube, we have developed a seamless one-click racing software solution for you. Simply launch a single application and start racing immediately. To make this possible, we have fully integrated our PitStopApp directly into Tuner.

Connect to PC diagram

Install & Start Tuner

1
Connect Delta PRO SC
The Delta PRO SC will be shown here once connected. Double click to customize the wheel.
2
Update Firmware
If a new firmware update is available, an Update Firmware button will appear.
Connect to PC diagram

Input Tab

3
Inputs
View the currently pressed inputs on the wheel along with their corresponding mappings.
4
Paddle Control
View Clutch ouput and setup bitepoint.
5
Tab Controler
Jump between 3 pages. Input (currently), Dash & LED.
Connect to PC diagram

Dash Tab

6
Display Brightness
Change the brightness of the display.
7
Dashboard selector
Click to change your displayed Dash on the screen.
Connect to PC diagram

LED Tab

8
Customize LEDs
Click on a button or Encoder to customize LED colors.
9
LED Settings
Change color profiles, led brightness & animations here.
10
Wheel Settings
Click the icon and then "configure wheel" to change wheel settings like clutch calibration, shifter calibration, MultiLink setup and much more.

Wheel Settings

Find out how you can setup your clutch, dial in the MultiLink and much more!